B - Table of contents
A- Orientation diagram 2
B - Table of contents 3
C - Reading guide 5
C.1 - How to use these operating instructions 5
D - Safety information 6
D.1- Remaining risks according to ISO EN 12100-2 6
D.2 - Safety decals 6
D.3 - Intended use 6
D.4 - Safety information 6
D.5 - Noise emission 7
D.6 - Dust emission 7
F- EC Declaration of Conformity / Techn. Data 9
F.1 - EC Declaration of Conformity 9
F.2 - Technical data 9
1 - Assembly machine setup 10
1.1 - Unpacking and assembly 10
1.1.1) Assembly machine space requirement 10
1.1.2) Unpacking assembly machine and attaching to a suitable table 10
1.1.3) Attaching base ruler 10
1.1.4) Attaching swivel stops 10
1.1.5) Attaching work table 11
1.2 - Connecting to compressed air system 11
1.2.1) Connecting air supply 11
1.2.2) Setting operating pressure 11
1.3 - Electrical connection 11
1.3.1) Electrical connection 11
1.4 - Dust extraction 12
1.4.1) Connecting extraction system to the assembly machine 12
1.4.2) Attaching the extraction system with the controller 12
2 - Description of operator panels 13
2.1 - Description of operator panels 13
2.1.1) Designation of operating elements 13
2.1.2) Feed switch 13
2.1.3) Hold down clamp switch 13
3 - Assembly 14
3.1 - Furniture hinge assembly 14
3.1.1) Required parts 14
3.1.2) Setting drill bit length 14
3.1.3) Setting drilling pattern 14
3.1.4) Inserting drill bits 14
3.1.5) Setting drilling depth 14
3.1.6) Drilling depth stop 15
3.1.7) Setting cam speed 15
3.1.8) Checking cam brake 15
3.1.9) Setting cam brake 15
3.1.10) Setting the stop system 15
3.1.11) Setting swivel stops 16
3.1.12) Placing door on the work top and pushing up against the stop or marking line 16
3.1.13) Setting hold down clamps to the material thickness 16
3.1.14) Attaching insertion ram to swing arm 16
3.1.15) Clipping furniture hinge on to the insertion ram 17
3.1.16) Drilling 17
3.1.17) Checking the tilt adjustment of the swing arm 17
3.1.18) Inserting the furniture hinge 17
4 - Assembly 18
4.1 - Cruciform mounting plate assembly 18
4.1.1) Required parts 18
4.1.2) Setting drill bit length 18
4.1.3) Setting drilling pattern 18
4.1.4) Installing drill bits into the chuck 18
4.1.5) Checking drilling depth setting 18
4.1.6) Setting the cam speed 18
4.1.7) Setting the stop system 18
4.1.8) Setting swivel stops 18
To Next Page
Loading...
Need help?
General
