YH-600B Pro User Manual V3.0
22 / 88
CAUTIONS!
• If the device is not used for a long time, a time setting window
will automatically pop up when you reuse it. Users need to
update the date and time according to actual time, then
choose “Save and Exit” to enter the standby interface.
• If the present time displayed on the device is later than the
preset record starting time, the device will immediately begin
to record.
10.2.2 Accessing the Standby Interface
The device automatically enters the standby interface after it is
started, as shown in Fig 1-11.
There are six icons in the standby interface: Record , Setup
, Data , Tools , Battery and TF card . The
yellow frame can switch among the four icons of Record, Setup,
Data, and Tools, and when it falls on an icon, press the On-Off /
OK Button to enter the corresponding interface. The
device can be turned off if the On-Off / OK Button is
pressed and held for five seconds in the standby interface.
Fig 1-11 Standby interface
CAUTION!
• In all interfaces the screen will dim if there is no operation
within the preset screen backlight timeout. Press any key in
To Next Page
Loading...