BMC YH-600B Pro

YH-600B Pro User Manual V3.0
25 / 88
10.2.3.2 “Record” Interface
If there are no wearing alerts, the “Record” interface can be
accessed directly. The time notification (0:00:00) in the upper left
corner of the “Record” interface flickers. Press and hold the
On-Off / OK Button for two seconds to start timing and
recording monitored data in the device.
If there is no operation within the preset screen backlight timeout
(except when the screen is set to stay bright all the time), the
screen will turn off automatically. Pressing any key can light up the
screen again. When recording is completed, press the On-Off /
OK Button and Shift Button simultaneously to exit the
“Record” interface and return to the standby interface.
The “Record” interface of YH-600B Pro, as shown in Fig 1-12.
Snore waveform
Airflow waveform
Recording time
CPAP pressure
Blood oxygen saturation Pulse rate
Body position
Thoracoabdominal
Respiration
Fig 1-12 “Record” interface of YH-600B Pro
SpO
2
(%):
Blood oxygen saturation expressed in
percentage
PR (bpm):
Pulse rate expressed as beats per
minute (bpm)
Recording time:
The length of a recording