CAUTION
The gate will move freely and uncontrolled when the gate operator is removed
from the gate. ONLY disconnect the operator when the power source has
been disabled
(ie. battery or transformer is off and the gate is NOT moving)
Manually Opening and Closing Gate
Disconnecting the Opener
1. Place release key into the release
bolt and unscrew fully
2. Pull actuator arm off gate bracket
3. Now the gate will swing freely
The gate can be opened and closed
manually when the actuator is
disconnected.
If leaving the actuator arm off the gate
please disconnect power to avoid
damaging the motor or cable.
DO NOT have the release bolt done
up tight as this will make for a difcult
release of the actuator arm. May also
cause jamming and or binding.
Release
Key
Release
Bolt
Actuator
Arm
Gate
Bracket
To Next Page
Loading...