Remote Learning
To learn new remotes to your control board.
Press the Learn button for 2 seconds and then release. The STATE red LED
light will go out. Now press button A on your remote once for 2 seconds or
until LED light begins to ash, the control board will “BEEP” once and display
the remote number you just learnt.
Remote 1 will show 01, remote 5 will show 05 etc.
The STATE red LED light will come back on solid.
Your remote is now tuned in.
Button B and C will automatically be assigned functions.
These functions cannot be altered or removed.
Button A Full open / close for Dual swing gate and Single swing gate
Button B Full open / close of Single swing gate, even if your gate is a
Dual swing gate, it will activate the gate wired to
MOTOR 2 (main)
Button C Party mode function. Party mode is used to override auto
close. It will override P7 and P8 auto close functions. You
must be within 1 metre of the gate to ensure you are within
working range for the remote.
Button D Empty
Erasing Remotes
Press and hold the Learn button for 8 seconds, the buzzer will beep and the
digital display will read 00. At this time, all the information stored in the on
board receiver has been deleted, release the Learn button.
Remote distance – up to 30 metres. This distance will vary greatly due to site
interference that may not be visible to the eye. Some sites will allow for
greater range than 30 metres, some sites might only achieve 5 metres.
Remote frequency – Rolling code 433mhz
*Only genuine remotes will operate with the on board receiver. To ensure your
remote is a genuine remote, you will notice the small LED light will icker an
ORANGE colour when you press one of the 4 buttons on your remote for 2
seconds or until the light starts to icker.
Remote Storage – The on board receiver can store up to 120 remotes.
Remotes
To Next Page
Loading...