Learning Your Control Board
After installing the actuator arm/s and completing the wiring as shown in the
wiring manual for your gate opener kit, have the gate/s in the open position.
If your unit is an ELECTRIC kit with a TRANSFORMER, turn your transformer
on now. The control board will make a “BEEP” sound and then run through
a start-up sequence which you will see on the digital display labelled MENU.
Wait 10 seconds for the control board to
nalise this step.
If your unit is a SOLAR POWERED kit, connect the SOLAR PANEL to your
regulator and connect the battery up to the power cables. The control board
will make a “BEEP” sound and then run through a
start-up sequence which you will see on the digital display labelled MENU.
Wait 10 seconds for the control board to nalise this step.
If your control board came to you with a complete gate kit, your
remotes will already be tuned in.
For a dual swing gate, your remote buttons will be:
Button A Controls Dual gate open / close
Button B Controls Single (Main Motor) gate open / close
Button C Party mode, this feature overrides auto close.
*Auto close is turned off, you will need to turn this on
yourself if you would like this feature.
Refer to Menu settings to set this up.
Button D Spare button, not in use.
For a single swing gate, your remote buttons will be:
Button A Controls Single (Main Motor) gate open / close
Button B Controls Single (Main Motor) gate open / close
Button C Party mode, this feature overrides auto close.
*Auto close is turned off, you will need to turn this on
yourself if you would like this feature.
Refer to Menu settings to set this up.
Button D Spare button, not in use.
To Next Page
Loading...