Dual swing AUTO TRAVEL LEARN procedure:
ENSURE THE GATE WAY ENTRANCE IS
CLEAR OR ANY OBSTRUCTIONS.
To perform the ‘AUTO TRAVEL LEARN’ function, you will need to activate your
gate opener with a remote. Press Button A for 2 seconds or until the small
LED light on the remote ickers orange, now release Button A on the remote.
You should observe “OP” appearing on the Digital Display “MENU”.
For a dual swing gate, the “MENU” will show OP to say the control board has
put Motor 1 gate into an OPEN position, the “MENU” will then show SP to say
the control board has turned Motor 1 off.
The “MENU” will repeat this sequence for Motor 2. With the control board now
knowing your gates are in the open position, you will need to press the DEC
and INC buttons at the same time for 5 seconds (you must press and hold in
both buttons at the same time for this to work, pressing the buttons individually
rst will not allow the control board to run its ‘AUTO TRAVEL LEARN’
function).
The gate connected to Motor 1 will close rst, the “MENU” will display CL
(Close), after Motor 1 has closed the gate, the “MENU” will
display SP (Stop). Motor 2 will now close with the “MENU” displaying CL
(Close), after Motor 2 has closed the gate, the “MENU” will display SP (Stop).
1 to 2 seconds after Motor 2 has closed the gate it will activate again with the
“MENU displaying OP (Open), after Motor 2 has opened the gate, the “MENU”
will display SP (Stop). Motor 1 will now open the gate with the “MENU” dis-
playing OP (Open), once the gate is open the “MENU” will display SP (Stop).
Wait 10 seconds before operating the gate opener.
Press Button A on your remote for 2 seconds or until the orange LED light
starts to icker and then release the button. Check that your gates operate
correctly. Check if your force settings need to be adjusted. If they require
adjusting, please refer to the MENU settings to adjust.
Majority of gates won’t require any adjustments.
Learning Your Control Board
To Next Page
Loading...