Single swing AUTO TRAVEL LEARN procedure:
ENSURE THE GATE WAY ENTRANCE IS
CLEAR OR ANY OBSTRUCTIONS.
To perform the ‘AUTO TRAVEL LEARN’ function, you will need to activate your
gate opener with a remote. Press Button A for 2 seconds or until the small
LED light on the remote ickers orange, now release Button A on the remote.
You should observe “OP” appearing on the Digital Display “MENU”.
For a Single swing gate, the “MENU” will show OP to say the control board
has put Motor 2 gate into an OPEN position, the “MENU” will then show SP to
say the control board has turned Motor 2 off.
With the control board now knowing your gate is in the open position, you will
need to press the DEC and INC buttons at the same time for 5 seconds (you
must press and hold in both buttons at the same time for this to work, pressing
the buttons individually rst will not allow the control board to run its ‘AUTO
TRAVEL LEARN’ function).
The gate Motor 2 will now close with the “MENU” displaying CL (Close), after
Motor 2 has closed the gate, the “MENU” will display SP (Stop).
1 to 2 seconds after Motor 2 has closed the gate it will activate again with the
“MENU displaying OP (Open), after Motor 2 has opened the gate, the “MENU”
will display SP (Stop). Wait 10 seconds before operating the gate opener.
Press Button A on your remote for 2 seconds or until the orange LED light
starts to icker, then release the button. Check that your gate operates
correctly. Check if your force settings need to be adjusted. If they require
adjusting, please refer to the MENU settings to adjust.
Majority of gates won’t require any adjustments.
Learning Your Control Board
To Next Page
Loading...