SAFETY PRECAUTIONS
Please read the Safety Precautions before installing or using the BMPRO
Connect+ system. Be sure to observe all precautions without fail. Failure
to observe these instructions properly may result in personal damage, or
personal injury which depending on the circumstances may be serious and
cause loss of life.
WARNING
Correct installation is the most critical factor in ensuring the safe use of the system. If
every consideration of these instructions has been satisfied, the system will be safe to
operate.
Do not drop or vigorously shake the product as this may cause damage. Do not shock the
product or its accessories as this may cause the product to fail, catch fire or explode.
Stay away from magnetic equipment. Radiation may erase the information stored on this
product, causing it to become inoperative.
Electricity and water do not mix. Keep this product and your battery dry and do not
expose it to water or water vapor. Do not operate this product or battery near any sort of
liquid. Do not operate this product with wet hands.
Do not use this product in environments that are excessively hot, cold, dusty or humid or
where it will be exposed to magnetic fields or long periods of sunshine. Such exposure
may cause the product or your battery to fail, catch fire or explode.
Clean the housing of this product lightly with a dry or moist cotton cloth. Do not use
alcohol, thinners, benzene or any other chemical cleaner.
The system is a high precision electronic product. It contains no user-serviceable parts
inside. Do not try to dismantle, modify or repair it yourself. Disassembly, service or repair
by an unauthorized person will void the warranty.
Before using this product, check that cable connections to the battery are of correct
polarity. To protect against accidental short circuit, ensure that the shrouding supplied
with the batteries are always fitted to the battery terminals.
Do not install this product in the same compartment where flammable materials, such as
petrol is stored.
Do not use this product in any manner not specified by the manufacturer, or the
protection provided by the equipment may be impaired.
Product specifications are subject to change and improve without notice.
Designed by BMPRO, one of Australia’s leading power solution experts, the BMPRO
product range is proudly designed and manufactured in Melbourne, Australia, and
represent a high-quality product that will provide years of service.
DISCLAIMER: BMPRO accepts no liability for any loss or damage which may occur from
the improper or unsafe use of its products. Warranty is only valid if the unit has not been
modified or misused by the customer.
First published 2025-03-26
REV 1.0
Copyright © 2025
2
To Next Page
Loading...
