BMPRO CONNECT+ - Controller; Switch; Ive Replaced the Switch in My Rv, but It Doesnt Work

CONTROLLER
How do I change the date and time on my Controller?
If your system has a Controller, and you need to change the date and time:
1. Press the Settings button.
2. Press Date and Time.
3. Select the correct date and time.
4. Press Done to confirm.
SWITCH
I’ve replaced the Switch in my RV, but it doesn’t work?
You may need to pair the Switch to the Node before you can use the Switch.
The instructions are different depending on the control system you have.
If you have a Display:
1. Using the button on the Display, navigate to the Settings menu.
2. Using the button on the Display, navigate down to Advanced.
3. In the Advanced setting menu, use the button to navigate down to Pair
Switch.
4. Press the OK action button to put the node into Switch pairing mode.
5. Press any two buttons on the Switch at the same time.
6. The Switch will now be paired to the BMPRO Connect+ system.
If you have a Controller:
1. Press the Settings button.
2. At the bottom of the menu, select Pairing External Bluetooth Devices.
3. Select Pair Switch.
4. Press any 2 buttons on the switch at the same time
5. The switch will now be paired to the BMPRO Connect+ system.
If you have an RV Control Panel:
1. Press the Bluetooth Pair button twice on the RV Control Panel. The button
will begin flashing, showing it is in pairing mode.
2. Press any two buttons on the Switch at the same time.
3. The Switch will now be paired to the BMPRO Connect+ system.
How do I unpair all my Switches using the RV Control Panel?
1. Press and hold both the Bluetooth Pair and Living Room Light buttons for
20 seconds.
2. All connected Switches are now unpaired.
47