BMPRO CONNECT+ - Information for the User

INFORMATION FOR THE USER
This device complies with Part 15 of the FCC Rules, and Innovation, Science
and Economic Development Canada’s license-exempt RSS(s). Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including what may
have cause undesired operation.
Le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement
WARNING
Any changes or modification not expressly approved by BMPRO could void
compliance of the product and the user’s authority to operate this equipment.
AVERTISSEMENT
Tout changement ou modification non expressément approuvé par BMPRO
pourrait annuler la conformité du produit et le pouvoir de l’utilisateur d’utiliser cet
équipement.
This device meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough
evaluation of scientific studies. The standards include a substantial safety
margin designed to assure the safety of all persons regardless of age or
health. The SAR limit of USA (FCC) is 1.6 W/kg averaged. Device types: 77”
Quad Core Android Tablet without battery (FCC ID: 2ASJH-BMPRO7DI4) has
also been tested against this SAR limit. SAR information on this and other pad
can be viewed on - line at
http://www.fcc.gov/oet/ea/fccid/. Please use the device FCC ID number for
search. This device was tested simulation typical 0mm to body. To maintain
compliance with FCC RF exposure requirements, the use of accessories
should maintain a separation distance between the user’s bodies mentioned
above, the use of accessories should not contain metallic components in its
assembly, the use of accessories that do not satisfy these requirements may
not comply with FCC RF exposure requirements, and should be avoided.
4