From General Settings, you can:
9 Check the Bluetooth Connection between the Node and your
smartphone.
9 Establish a Remote Connection to the BMPRO Cloud.
For more information, refer to the section Cloud Control.
9 Enter the Winegard network name and password to connect to the
internet (model dependent).
For more information, refer to the section Winegard.
9 Set the Date and Time.
9 Set up a Wi-Fi Connection.
9 Perform software Updates.
9 Set Sensors Settings, allowing for the setting of tire pressure sensor
underpressure and over-temperature limits, and the toggling of sensors
on and off.
For more information, refer to the section Sensor Settings.
9 Check the wireless Battery Levels of any installed Switch.
For more information, refer to the section Checking the Battery in Your
Switch.
9 View Energy Center Settings.
For more information, refer to the section Energy Center Settings.
9 Set Motor Settings, which depending on the level of controller installed,
can be used to set zero-point calibration (model dependent).
For more information, refer to the section Motor Settings.
9 View Solar Controller Settings.
For more information, refer to the section Solar Controller Settings.
9 Set Load Shedding Settings.
9 Access a digital version of the User Manual.
9 View information About SYSTEM: all about the BMPRO Connect+ system,
Node version, app version, etc.
9 View the BMPRO Privacy Policy.
9 Set your Preferences for measurement units and notifications.
For more information, refer to the section Preferences.
9 View Diagnostics, showing any detected faults.
For more information, refer to the section Diagnostics.
9 Perform the process of Pairing External Bluetooth Devices, such as iOS
or Android devices or a wall switch.
34
To Next Page
Loading...
