MARK I NAVIGATION SYSTEM SOFTWARE LOADING
As new operational software becomes
available, it will be necessary to update existing
navigation computers with this latest version
software.
As with other BMW systems, the software will
be distributed on a CD. It will be introduced by
an SI or IDC bulletin describing the revisions of
the new CD and the loading procedures as
outlined below.
The software loading procedure is also
required if the troubleshooting procedures of
the DIS tester call for it..
The procedure for loading the updated software is a s follows:
Remove the existing digitized map
database CD.
Turn the ignition switch On.
Insert the new software CD.
Any currently running program will be
interrupted and the message Please Wait
will be displayed on the monitor screen.
The new software will automatically be
installed. When the procedure is
complete, the screen will display
Software Loaded Successfully.
The software loading must be
acknowledged by pressing the rotary
knob and removing the software CD.
The digitized map CD is then reinstalled -
followed by a map guided test drive to
ensure proper operation of the navigation
system.
To Next Page
Loading...
Need help?
General
