11
User's Manual
10. Surround Setup Controls
MAIN: If your front speakers are capable
of good bass performance, set this to
LARGE.
CENTER: If you have a center speaker,
set this to ON.
SURROUND: If you have a pair of sur-
round speakers, set this to ON.
SUB: If you have a Subwoofer, set this
to ON.
CENTER DELAY: This adjusts the time
delay of the center speaker.
SURROUND DELAY: This adjusts the time
delay of the surround speakers.
11. RS-232 Jack
This allows the Processor to be operated by
computer software control. It connects to the
serial jack of a home computer or controller.
12. Video Screen Trigger
These are used in custom installations to
trigger video screen deployment. When a
video component is selected, the video
screen will come down after a short delay.
13. Chassis Ground Screw
This is used for the ground connection
wire of a turntable.
14. Audio Inputs
These audio inputs connect to the outputs
of your CD, DAT/TAPE, PHONO and TAPE.
Any standard audio component can be
connected to CD, DAT/TAPE or TAPE, but
only a turntable (Moving Magnet) can be
connected to the PHONO input.
Note: There is no TAPE input selector on
the front panel or the remote control. If you
select DAT/TAPE, the Processor will auto-
matically select either the DAT/TAPE or TAPE
input, whichever is playing. If you have both
DAT/TAPE and TAPE connected, make sure
that only one is playing at a time.
15. External Processor Input
This connects to the output of an analog
external processor (see #18).
16. Digital Inputs
These inputs connect to the digital
outputs of your audio/video components. The
DBS/BS and LD/DVD inputs have two op-
tions, optical or coaxial. The CD, VCR and
DAT/TAPE digital inputs are coaxial.
Whenever one of these inputs is selected
from the front panel or remote, the Theater
Grand Processor will automatically select the
digital input if there is a signal present,
otherwise it will select the corresponding
analog input.
17. Tape Audio Output
This connects to the input of a Tape Deck
and allows recording of whichever input is
selected.
18. External Processor Output
This connects to the input of an analog
external processor. This can then be selected
by holding down the PANEL DIM button until
the message ADPT ON appears in the
display. The two channel analog signal will
then pass through your external processor
and back in through the inputs (see #15).
19. Unbalanced Audio Outputs
These line-level RCA outputs connect to
the inputs of your amplifier and powered
subwoofer(s).
20. Seven-Axis Outputs
These outputs provide two side channels
to complement the left, center, right and
surround channels.
21. IEC Linecord Socket
The Theater Grand Processor comes with
a detachable Linecord which connects here.
Rear Panel Features
To Next Page
Loading...