BobsCNC QUANTUM MAX User Manual

149
Step 9 Wire Management.
WARNING In order to reduce electrical
noise which can interfere with the proper
operation of the Stepper Motors and Controller, it
is required that all the wiring and securing of
loose wires be performed as illustrated in the
manual. Failure to do so may result in poor
machine performance.
Step 9a Make a loop of cord approximately six
inches from the Makita Router to the
midpoint of the loop. This will allow the
Makita Router to travel up and down the
Z Axis without stress to the Power Cord.

BobsCNC QUANTUM MAX Specifications

General

Brand	BobsCNC
Model	QUANTUM MAX
Category	Control Systems
Language	English