BobsCNC QUANTUM MAX User Manual

152
Step 9e Holding the Makita Router cord at underside of the
two elongated holes in the top of the Gantry Top
Brace located just to the left of the Controller,
measure enough cord to allow the Y Carriage
Assembly to travel back and forth across the Gantry
Assembly without pulling on the Router cord. In
addition, leave a wide enough loop of cord so that it
will not interfere with the Stepper and Home Switch
wires.

BobsCNC QUANTUM MAX Specifications

General

Brand	BobsCNC
Model	QUANTUM MAX
Category	Control Systems
Language	English