BobsCNC QUANTUM MAX User Manual

151
Bundle enough wire so that when
the wires are attached to the
Controller Mount, the Y Carriage
Assembly can travel back and forth
across the Gantry Assembly without
pulling on the wires.
Secure the wires to the Controller.
Mount with a Zip Tie to the “YZ HS”
mounting holes.
Step 9d Route the Makita
Router cord through
the Gantry Back
Brace and Gantry
Side as shown.

BobsCNC QUANTUM MAX Specifications

General

Brand	BobsCNC
Model	QUANTUM MAX
Category	Control Systems
Language	English