7.0 Configuration
The Lemur series printer is factory configured for a variety of customer requirements.
For a comparison of the different electronics packages, refer to the BOCA Systems website under the BASIC
section.
For a listing of configuration choices, refer to the BOCA Systems website under the SPECIFICATIONS section.
Printers are configured with a reverse adjustable paper guide (RADJW) set to the customer’s specified width or
optional adjustable paper guide (ADJ4, ADJW, ADJ2 & RADJ4).
Reverse adjustable (RADJW & RADJ4) path printer is set to the customer’s specified width. If this setting
requires changing then the following will need to be done to ensure proper operation.
1. The paper path slider bar needs to be adjusted for the width stock being used is printer will be using
a different width media than what it was originally configured for (see 6.1 Media Width Adjustment).
Adjustable (ADJ4, ADJW & ADJ2) paper path printer may leave the factory with the slider bar set to its widest
setting (ADJ4 = 4”, ADJW = 3.25” & ADJ2 = 2”). Please check to make sure the paper path slider bar is
properly adjusted for the width stock being used. (See 6.1 Media Width Adjustment.
Click here to return to > Table of Contents
To Next Page
Loading...
