Boge base control - General Safety Information; 2.1 General Safety Information

BOGE base control for scroll compressors Page 5
Safety 2.1 General Safety Information
Part 2: Safety 2.1 General Safety Information
Prior to Commissioning
and Operation
The following must be observed prior to commissioning and operation of the
base control:
– These instructions must be read thoroughly and understood before com-
missioning / operating the control.
– These instructions must be available at all times at the place of operation
of the control.
– Changes to parameters and settings may only be carried out by authorized,
qualified personnel, see also "Personnel Requirements".
– Work on the control that requires the switch cabinet to be opened may only
be carried out by an authorized, qualified electrician, see also "Personnel
Requirements".
– Prior to initial commissioning of the control unit, check for visible transport
damage.
– Damage to the control that affects safe operation of the machine must be
rectified immediately.
Intended Use
The control is intended exclusively for the correct operation of a BOGE scroll
compressor and its connected accessories.
Reasonably Foreseeable
Misuse
The control is not suitable for use with other types of compressed air genera-
tors or compressors from other manufacturers.