Boge base control User Manual

BOGE base control for scroll compressors Page 31
Troubleshooting 6.1 Message Types
Part 6: Troubleshoot-
ing
6.1 Message Types
Two types of message may appear:
Tab. 6.1: Message Types
6.2 Processing Messages
The following procedure is recommended when an event occurs that causes
one of the message types to appear:
1. Determine / narrow down the cause of the message using the table below,
which contains a list of messages and message codes.
2. If necessary, have the fault rectified by BOGE Service personnel.
3. Acknowledge the message (see page 33).
 As soon as the cause has been rectified successfully and the message
acknowledged, the compressor should be operational again without
restrictions.
No. Message Type Meaning Visualization / Display of the Message Type
1. Warning / mainte-
nance message
A warning has been issued or servicing
work must be carried out.
The compressor is still operational.
The "Fault" indicator lamp is flashing
rapidly. The wrench symbol is
flashing on the main display.
Pressing the Info key displays
the message code.
2. Fault message The control is signaling a fault.
The compressor is switched off.
The "Fault" indicator lamp flashes
and a message code is shown on
the main display.
+
CAUTION
Compressor Damage
Arranging to have faults and problems rectified (including maintenance
and repair work) by unauthorized or unqualified personnel may damage or
destroy the compressor.
 Faults and problems may only be rectified by authorized and qualified
personnel or BOGE Service personnel.
 If in doubt, contact BOGE Service.

Boge base control Specifications

General

Brand	Boge
Model	base control
Category	Control Unit
Language	English