bolid S2000M - Page 50

FIRE AND ALARM CONSOLE
50
adding new password or “CHANGE” for changing existing
password.
Type password and press “ENT”. Typing symbols will be
displayed as “*”.If signal “Error” has sounded it indicates after
password typing it indicates that this password has already
existed and if so enter another password.
Type password again. If signal “Error” has sounded it indicates
that first typed password differs from the second typed
password.
For direct device loop operation, select “W/O PART
CONTRL”. For partition operation, select “W. PART
CONTROL”.
Now set password authority level.
Variant 1. Password for direct device loop operation.
Select one of offered loop control access levels (“ARM and
DISARM”, “ARM w/o DISARM”, “MAX AUTHORITY”)
and press “ENT”.
Variant 2. Password for partition operation.
Number of authority level has been requested. Authority level
describes the user rights for partitions operation. Valid values
are from 1 to 252. Authority level settings are described in the
item 2.1.7.3.
Console allows password programming as PIN-codes, Touch Memory keys or Proximity
cards. Touch Memory keys and Proximity cards are entered from Touch Memory or Proximity
readers connected to “S2000-4” or “S2000-2” device identically to the procedure described
above replacing symbol typing by key touching or card reading.
IMPORTANT! Touch Memory keys or Proximity cards can be read by the console only
if they are not writen in ‘S2000-4’ or “S2000-2” device configuration.
Deleting password
Enter in programming menu (press button “PRG”).
Type engineer password.
Select “SETTINGS” menu item by “
4”, “3” and “ENT”
keys, or press hot key “5”.
Select “USER CODES” menu item by “
4”, “3” and “ENT”
keys, or press hot key “2”.
Enter password number (from 1 to 2047), or select valid value
by “
4”, “3” keys and press “ENT”.
Select “DELETE” for deleting password.
NEW CODE:
v ARM and DISARM
v ARM w/o DISARM
v MAX AUTHORITY
CONFIRM:
vW/O PART CONTRL
v W. PART CONTROL
AUTHORITY #:_
v DELETE
ENTER CODE:_
v 5 SETTINGS
v USER CODES
USER NUMBER:_