FIRE AND ALARM CONSOLE
54
confirmed the 20 minutes delay will be counted, with the time before password resetting being
displayed by LCD. At the end of 20 min delay console configuration takes default value. In any
delayed time resetting can be cancelled by pressing button “
CLR”.
2.2.6 Console version update
Console software can be updated. The opportunity can be used for getting new options
and remove possible current version bugs. For update are required: PC with Windows
98/2000/XP, connection cable for RS-232 interface, update program
‘ORION_PROG.exe’ and
file with libraries for different ‘S2000M’ console versions (extention ‘chp’). Console connection
to the computer for version update is shown on the Figure 5. Cable has to correspond shown on
the picture type.
‘ORION_PROG.exe’ program and file with libraries can be gat by electronic
mail, on address
info@bolid.ru.
Versions update steps. Set ‘S2000M’ console in programming mode. Run
‘ORION_PROG.exe’. Select COM-port, connected to the consol. Run device search, pressing
‘Start searching’ button. Program have to detects ‘S2000M’ console (displayed as ‘S2000’
console version 2.04) and, possible, some other devices connected through RS-485 interface.
Select it from detected device list and press ‘PRG’. Open file with console libraries. Program
displays list of versions for given console device. Select required version and press ‘Write’ key.
After few seconds program prepare data for writing, and write new firmware. Write operation
console has to shows ‘FIRMWARE LOADING...’ on the indicator, and LED indicator
‘READY’ blinks, indication data transmission to the console.
3 STORAGE
3.1 At console store acids, alkalis, corrosive gases and other noxious corrosive vapors
have to absent.
3.2
Storage life in package has to be below 12 monthes.
4 TRANSPORTATION
4.1 Packed consoles transportation can be done by any transport in covered containers.
5 CERTIFICATION INFORMATION
6.1 S2000M intrusion and fire-alarm console corresponds to Russian Federation state
standards and have:
-
certificate of conformity to Russian state standards on alarm and fire systems;
-
certificate of conformity to Russian fire norms.
6.2
NVP BOLID’s quality management corresponds to ISO 9001 standard.
6 INFORMATION ABOUT MANUFACTURER
NVP BOLID
Pionerskaya st., 4
Korolev
Moscow region
Russia
141070
Tel/fax: +7 (495) 513 4342, 513 4351, 516 9372, 516 9373, 777 4020
http://www.bolid.ru
E-mail: info@bolid.ru
To Next Page
Loading...