— To the extent necessary, amply secure the surrounding area
when performing maintenance. Cordon of
f the working area
with a red and white safety chain and a warning sign.
— Relieve the pressure in the Börger machine according to
Ä
Chapter 6.1.2 “Pressure relief” on page 109.
1. Remove the required flange connections and maintenance
openings to get to the working chamber of the Börger
machine.
2. Thoroughly clean the rotating parts and the working chamber
of the machine from deposits and contamination.
3. Thoroughly clean all parts before reinstalling removed parts.
4. Check all removed parts for wear and only reuse them if they
are undamaged.
5. Only replace worn components, seals, screws, nuts etc., but
especially the wetted parts, with original spare parts.
6. Reassemble the flange connections and maintenance open-
ings that have been loosened previously
.
Maintenance and Repairs
BA-Classic FL_en-US, 03.05.2018 www.boerger.de / www.boerger.com 113
To Next Page
Loading...