2.4 Residual risk
Even when all safety instructions are adhered to, there are residual
risks involved in operating the Börger machine as detailed below
.
All persons that work on and with the Börger machine must be
aware of these residual risks and observe the associated instruc-
tions to avoid accidents or damage caused by these residual risks.
It may be necessary to remove on-site safety equipment during
installation and when making modifications. This causes a residual
risk and potential danger that each operating person must be
aware of:
DANGER!
Risk of fatal injury due to electric power!
There is an immediate risk of fatal electric shock if live compo-
nents are touched. Damage to the insulation of the individual
components can be fatal.
— Have all work on the electrical equipment performed by skilled
electricians.
—
In the event of damage to the insulation, cut off the power
supply immediately and initiate repairs.
— Before working on live components of electrical systems and
equipment, de-energize these components and secure them
in this state for the duration of the work. Adhere to the fol-
lowing safety rules in this regard:
— Disconnect.
— Secure against restart.
— Verify that components have been de-energized.
— Ground and short-circuit.
— Cover or shield any adjacent live components.
— Never bypass or disable any fuses. Comply with the correct
amperage specification when replacing fuses.
— Keep moisture away from all live components. This may lead
to short circuits.
Electric current
Safety
BA-Classic FL_en-US, 03.05.2018 www.boerger.de / www.boerger.com 17
To Next Page
Loading...