9.4.1 Tools / installation aid
The tools below are needed to carry out the required checks
and correct installation:
Standard tools
Tools for electrical work
— These tools shall comply with the international standard IEC
60900 (identical to EN 60900
for Europe and DIN EN 60900 for
Germany).
— The standard applies to “Insulated and insulating hand
tools” used for live working and work near live parts, with
voltage ratings up to 1000V AC or 1500V DC.
— Products designed and manufactured according to this
standard contribute to the user’s safety, provided they are used
by qualified electricians in compliance with the safe working
practices and the operating manual (if applicable).
Tools, general
— Various hexagon socket wrenches and/or sockets for hexagon
socket head cap screws.
—
Various open-end / ring spanners and/or sockets for hexagon
head screws.
— Hammer
— Soft face hammer
— Screw drivers in various sizes
— Lever
Appendix
BA-Classic FL_en-US, 03.05.2018www.boerger.de / www.boerger.com180
To Next Page
Loading...