Special tools
Hammer drill
— A hammer drill is a power tool to drill holes into mineral mate-
rial, e.g. stone or concrete. Through the impact, the cutting
edge of the drill pulverizes the material
Hoists
Lifting and slinging gear must be designed and dimensioned ade-
quately according to the particular hazard and the loads occurring
during transport.
Multitool (M)
— Special tool (A) for rotating seal holding bushes
—
Push-in tool (B) for mechanical seals
— (Remove handle!)
Slide hammer
For pulling out and removing deep-set parts, special adaptations
allow versatile use for other parts as well. The parts are pulled of
f
by striking them with the slide hammer.
Torque wrench
— A torque wrench is a hand-held fastening tool, with which a
defined torque can be applied to a connecting element (screw
or nut), so as to ensure the required clamping force between
the connecting components even at maximum operating
forces.
W... rotor puller
Appendix
BA-Classic FL_en-US, 03.05.2018 www.boerger.de / www.boerger.com 181
To Next Page
Loading...