DANGER!
Risk of injury due to rotating parts!
Moving parts can cause severe injury.
— Do not reach into rotating parts or handle rotating parts when
the machine is in operation.
—
Never open protective covers when in operation.
—
Perform work on the Börger machine only when stationary.
— Observe the delay time: Prior to opening protective covers,
make sure that all components have stopped moving.
— Shut down the Börger machine and upstream and down-
stream system components as described in
Ä
Chapter 5.3
“Downtimes” on page 93 before carrying out any work on the
Börger machine or accessories.
— The operating person is obligated to check that all safety
equipment is installed as described in
Ä
Chapter 2.8
“Description of the safety equipment” on page 25 and fully
functional before putting the machine into operation.
— The Börger machine must only be switched on when the
inlet and outlet connections have been established and the
maintenance openings have been securely installed.
CAUTION!
Risk of burns!
Particularly when used outside at correspondingly high ambient
temperatures and high medium temperatures, individual parts of
the Börger machine can become hot and should not be touched
during operation.
Stop the feed and shut down the Börger machine prior to any
troubleshooting, maintenance and repair work on the Börger
machine and the accessories.
Allow the system to cool down completely
, if necessary
, before
carrying out troubleshooting, maintenance and repair work.
Avoid dust formation as this contributes to heat build-up.
Moving parts
Hot surfaces
Safety
BA-Classic FL_en-US, 03.05.2018www.boerger.de / www.boerger.com18
To Next Page
Loading...