Borger Classic FL 776 - Page 5

3.1.8 Pipe connections on inlet and outlet.............................................................................. 44
3.1.9
Units / drive options....................................................................................................... 46
3.1.10 Options and accessories............................................................................................... 47
3.2 Operating principle........................................................................................................ 48
3.3 Technical data................................................................................................................ 49
3.3.1 Dimensions.................................................................................................................... 49
3.3.2 Performance data and maximum loads......................................................................... 52
4 Transportation, Storage and Installation................................................................... 55
4.1 Transportation................................................................................................................ 55
4.2 As-delivered condition................................................................................................... 57
4.3 Storage and interim storage.......................................................................................... 58
4.3.1 Storage.......................................................................................................................... 58
4.3.2 Interim storage............................................................................................................... 61
4.4 Installation..................................................................................................................... 62
4.4.1 Preparation for installation............................................................................................. 62
4.4.2 Positioning..................................................................................................................... 66
4.4.3 Installing the inlet and outlet.......................................................................................... 68
4.4.4 Aligning the unit............................................................................................................. 71
4.4.5 Electrical, hydraulic and PTO shaft connection............................................................. 73
4.5 Checks before commissioning....................................................................................... 79
4.5.1 Checking smooth running following storage and long downtimes................................. 80
4.5.2 Checking readiness for operation.................................................................................. 81
4.5.3 Checking the flow direction............................................................................................ 83
5 Operation...................................................................................................................... 86
5.1 Commissioning.............................................................................................................. 89
5.1.1 Test run with medium..................................................................................................... 90
5.1.2 Complete commissioning.............................................................................................. 91
5.2 Continuous operation.................................................................................................... 92
5.3 Downtimes..................................................................................................................... 93
5.4 Emergency shut-down................................................................................................... 94
5.5 Malfunctions.................................................................................................................. 95
5.6 Measures following on demand work!......................................................................... 104
6 Maintenance and Repairs......................................................................................... 105
6.1 Machine care............................................................................................................... 106
6.1.1 Cleaning the outside.................................................................................................... 108
6.1.2 Pressure relief............................................................................................................. 109
Table of Contents
BA-Classic FL_en-US, 03.05.2018 www.boerger.de / www.boerger.com 5