8 en | Table of Contents AMAX panel 2000 / AMAX panel 2000 EN
F.01U.241.127 | V4 | 2011.12 Installation Manual Bosch Sicherheitssysteme GmbH
8.1.8 Zone Tamper 63
8.1.9 Zone Fault 63
8.1.10 Zone Report 63
8.1.11 Zone Chime Mode 63
8.2 System Reporting Information 63
8.2.1 System Option Programming Definition 64
8.2.2 System Report and Memory Definition 65
8.2.3 Auto Test Report 68
8.3 System Event Memory Recall 69
8.3.1 Keypad Play Back System Events 69
8.4 Output Process 69
8.4.1 Output Events Option 69
8.4.2 Output Type 72
8.4.3 Output Duration 72
8.4.4 Keypad Buzzer Alarm Output 72
8.4.5 Optional Relay Output 72
8.4.6 On-board LED Indicator 72
8.4.7 DX3010 Support 72
8.5 System Event Time 72
8.5.1 Entry Time 72
8.5.2 Exit Time 73
8.5.3 Keypad Lockout Time 73
8.5.4 System Power Up Wait Time 73
8.5.5 AC MAINS Fail Wait Time 73
8.6 Optional Equipment 73
8.6.1 RE012 E 2-Channel Hand-Held Keyfob 433 MHz 73
8.6.2 WE800E 433 MHz RF Receiver 73
8.6.3 ICP-EZPK Programming Key 73
8.6.4 A-Link Plus Software 73
8.6.5 DX3010 8 Relay Module 73
8.6.6 B420/DX4020/ITS-DX4020G GSM GPRS Communication Module 74
8.6.7 IUI-AMAX-LED8 8 Zone LED Keypad 74
8.6.8 IUI-AMAX-LCD8 8 Zone LCD Keypad 74
9 Technical Data 75
9.1 Specification 75
9.2 Interface Description 77
9.2.1 Terminals Internal Description 77
9.2.2 Connector Interface Description 77
10 Programming sheets 78
10.1 Receiver Programming 78
10.1.1 Receiver Parameters 78
10.1.2 Domestic Programming 79
10.2 System Report Options Programming 79
10.2.1 Report Options 79
10.2.2 Test Report Time Interval Setting 80
10.3 System Functions Programming 80
10.3.1 Ring Count 80