AMAX panel 2000 / AMAX panel 2000 EN Table of Contents | en 7
Bosch Sicherheitssysteme GmbH Installation Manual F.01U.241.127 | V4 | 2011.12
6.16 Add/delete User Codes 44
6.17 Add/delete Radio User Codes 44
6.18 Change Domestic Phone Number 45
6.19 Enter Programming Mode 45
6.20 Command 959 – Exit from installer’s programming mode without saving the programming data 45
6.21 Command 960 – Exit from installer’s programming mode with saving the programming data 46
6.22 Command 961 – Reset the control panel to factory default settings 46
6.23 Command 962 – Copy the control panel memory to the programming key 46
6.24 Command 963 – Copy the programming key to the control panel 47
6.25 Command 999 – Display the software version number 47
6.26 Default the control panel with the hardware 47
7 System Informations 1 48
7.1 Zone Processing when arming 48
7.2 Zone Processing when disarming 48
7.3 Alarm processing 48
7.4 Software 49
7.4.1 Remote Connect 49
7.4.2 Remote Connect with Customer Control 49
7.4.3 Remote Connect with Callback Verification 49
7.4.4 Remotely Arm/Disarm System by Programming Softwares 50
7.5 Domestic Dialing 50
7.5.1 Domestic Dialing Function 50
7.6 Reporting Formats 50
7.6.1 Transmission Formats 50
7.6.2 Contact ID Format 50
7.6.3 CFSK Format 51
7.7 Dialer Information 51
7.7.1 Telephone number for Receiver 1 - 4/IP Address and Port 52
7.7.2 Other Network Programming Option 52
7.7.3 Report Transmission Sequence 53
7.7.4 Receiver 1 - 4 Transmission Format 53
7.7.5 Receiver 1 - 4 Subscriber ID Number 54
7.7.6 Call back Telephone Number 54
7.7.7 Ring Count 54
7.8 Access Codes 54
7.8.1 Installer Code 54
7.8.2 AMAX panel 2000 / AMAX panel 2000 EN User Codes 54
7.8.3 User Codes 55
8 System Informations 2 56
8.1 General overview on zones 56
8.1.1 Zone Inputs 56
8.1.2 Zone programming 57
8.1.3 Zone Types 57
8.1.4 Zone Bypass 62
8.1.5 Forced Arming 62
8.1.6 Silent Alarm 62
8.1.7 Zone Lockout 62
To Next Page
Loading...
Need help?
General
