5. Press [#] to exit.
Bypassing Faults or Tamper Conditions
One or more faults or tamper conditions can be disabled for one
arming cycle. After bypassing a fault or tamper condition, you
can arm the system even when a fault or tamper condition
exists.
Only zone tampers can not be bypassed.
How to bypass a Fault or Tamper Condition
4 Enter your code + [3] [4] and press [#].
P The system beeps twice and fault or tamper conditions are
bypassed.
6.2
AMAX panel Bypassing | en 27
Bosch Sicherheitsysteme GmbH 2015.05 | 04 | F.01U.295.569
To Next Page
Loading...
