Bosch AVENAR panel - Page 50

50 en | Installation AVENAR panel
2022-07 | 5.0 | F.01U.378.910
System manual
Bosch Sicherheitssysteme GmbH
The FPP-5000-TI is connected directly to the LSN bus line and supplied with power via the bus
line.
You can find the installation instructions for the FPP‑5000‑TImodule at
www.boschsecurity.com (document number for installation instructions: F.01U.081.396).
The technical data can be found in FPP‑5000‑TITrouble Interface.
FPP-5000-TI13 Communication Interface
The Communication Interface is an extension for the External Power Supply Unit Kit only. It is
the communication interface between the External Power Supply Unit Kit and the panel, and
transmits the following faults to the panel:
– Mains fault
– Battery fault
– Battery internal resistance fault
– BCM Battery Controller Module fault
– Short 24 V outputs
– Ground fault
Additionally, with the programming software, the switching outputs can be programmed and
the settings for extended line monitoring can be done.