AVENAR panel AVENAR panel series | en 9
Bosch Sicherheitssysteme GmbH
System manual
2022-07 | 5.0 | F.01U.378.910
1 Panel controller 6 PRD 0004 A Panel Rail Long
2 Fire brigade peripheral module 7 Power supply unit
3 HBC 0010 A Panel Housing for 10
modules
8 Power supply bracket
4 Batteries 9 PRS-0002-C Panel Rail Short
5 Functional modules 10 BCM‑0000‑B Battery Controller Module
Functions
The panel provides complete flexibility and customized solutions for many applications.
The planning of the fire panel is supported by Safety Systems Designer for fire alarm systems.
The software provides information about the size and number of housings, the modules and
the energy balance calculation.
Depending on specific requirements, the planning involves choosing from the following
options:
– Housings for frame and wall mounting
– Selection of a basic housing
– Extension housing, optional
– Power supply housing, optional
– Installation kits (optional) for installation in 482.6mm (19") racks
– Panel controller, premium and standard license
The panel controller, premium and standard license, features fire detection, and
connectivity with panel and remote keypad of FPA series. Each panel controller contains a
hard coded software license. The licenses define the maximum panel network size and
availability of certain features and interfaces. In principle, the standard license provides
basic fire detection features according the standards. In addition, the premium license
provides interfaces for:
– Building management system (OPC, FSM-5000-FSI)
– Hierarchy panel (UGM-2040)
– Voice alarm system (Smart Safety Link)
In addition, the following comfort feature:
– Individual control of evacuation zones and fire controls.
For more information on software licenses, refer to
Panel controller, page 11
.
For information on panel networking, refer to the Networking guide.
– Panel rail
– Selection according to housing type and/or number of functional modules required
– Power supply
– Batteries
– Power supply units for additional power supply
– Power supply brackets
The power supply brackets on frame installation housings are pre-installed ex works;
for wall-mounted housings, power supply brackets can be selected as required.
– Thermal printer
– The thermal printer is used to document operating procedures on the panel, as well
as alarm and fault messages. Plain text can also be printed. Programming is carried
out via the programming software FSP-5000-RPS.
– Additional accessories
– Cable sets for special applications.
– Functional modules
To Next Page
Loading...
