Bosch D7412GV4 - Points; What is a Point?; Controlled Points

Programming the Control Panel
You can program the control panel with RPS using a network connection, USB connection,
modem/phone line or serial connection. Both USB and serial connections require a DX4010V2.
You can program some paramaters of the control panel with keypad programming.
RPS Programming over a Network Using the DX4020 Ethernet
Network Interface Module
For additional information, refer to IP Address Programming in the Conettix DX4020 Network
Interface Module Installation Guide .
RPS Programming over a Network Using the ITS-DX4020-G
GPRS/GSM Communicator
For additional information, refer to the Conettix ITS-DX4020-G Installation Guide.
RPS Programming Using the DX4010V2 RS-232/USB Serial
Interface Module
For additional information, refer to the DX4010V2 RS-232/USB Serial Interface Module
Installation Instructions.
RPS Programming Using the B420 Conettix Ethernet
Communication Module
For additional information, refer to Programming Through a Control Panel in the B420 Conettix
Ethernet Communication Module Installation and Operation Guide.
RPS Programming Using the B426 Conettix Ethernet
Communication Module
For additional information, refer to Programming Through a Control Panel in the B426 Conettix
Ethernet Communication Module Installation and Operation Guide.
Programming Using the Installer Menu
For additional information, refer to the Control Panels (D9412GV4/D7412GV4 v2.00) Installation
and System Reference Guide.
4
4.1
4.2
4.3
4.4
4.5
4.6
Control Panel Programming the Control Panel | en 13
Bosch Security Systems, Inc. Quick Reference Guide 2014.05 | 05 | F.01U.265.463