SIA CP-01 False Alarm Prevention Options
Notice!
Some programming parameters are preset for compliance with SIA standard CP-01 (false
alarm prevention). These settings are in AREA WIDE PARAMETERS→Area Parameters. They
affect control panel operation as described below.
– All On-No Exit=YES: This setting provides for a Perimeter Delay point to be faulted when
master arming each area, or the arming state defaults to Perimeter Delayed.
– Exit Delay Warning=YES: When this parameter is set to YES, the alarm bell pulses on and
off every two seconds for the remaining 10 sec of Exit Delay.
– Entry Delay Warning=YES: When this parameter is set to YES, the alarm bell pulses on
and off every two seconds for the remaining 10 sec of Entry Delay.
9.3
Control Panel Turning the System ON or OFF and Keypad Commands for B920/B930 | en 23
Bosch Security Systems, Inc. Quick Reference Guide 2014.05 | 05 | F.01U.265.463
To Next Page
Loading...
