Bosch D7412GV4 - Warning Displays and Tones; Keypad Quiets for Keystrokes; Silence the Alarm Tone

Programming the Control Panel for Common Reporting
Options
Set Up Daily Test Report Using RPS
1. Go to SCHEDULES→Skeds.
2. Enter Function Code 9 (Test Report) in an unused Sked.
3. Select NO for the Deferred parameter to send test reports regardless of other test
reports sending between scheduled test reports.
4. Select NO for the Hourly parameter to send test reports only when the sked executes and
not every hour.
5. Enter the time at which you wish the schedule to send the report.
6. Leave the Date parameter disabled so that the sked executes by days of the week instead
of only on a selected date.
7. Select YES for each day of the week.
8. Select NO for:
– Except On Holiday
– Holidays 1 - 4
Set Up Open and Close Reports Using RPS
Area Wide Parameters
To report each area independently:
– Go to AREA WIDE PARAMETERS→Area/Bell,Open/Close Options→Acct Open/Close in
RPS. Select NO (default).
– Go to Area Open/Close in RPS). Select YES (default).
To report by account (Close signal is sent when the last area in an account is armed; Open
signal is sent when the first area is disarmed):
– Go to AREA WIDE PARAMETERS→Area/Bell,Open/Close Options→Acct Open/Close in
RPS. Select YES.
– Go to Area Open/Close in RPS. Select NO.
Notice!
If you want Perimeter Open and Close, select Perimeter O/C = YES.
Set Authority Level
1. Go to USER INTERFACE→Authority Levels.
2. Go to the Authority Level to be used by users sending Open and Close reports.
3. Select E (enabled) for Area Open/Close.
4. Select E for Restricted Open/Close.
5. Select E for Perimeter Open/Close.
6
6.1
6.2
6.2.1
6.2.2
16 en | Programming the Control Panel for Common Reporting Options Control Panel
2014.05 | 05 | F.01U.265.463 Quick Reference Guide Bosch Security Systems, Inc.