Turning the System ON or OFF and Keypad Commands
for B920/B930
Turning the System On and Off
Turning All On (Arming)
Enter the passcode and [Enter] or [ENTER] to turn on (arm) all areas where the user has
authority and are areas within the scope of the keypad.
Turning Off (Disarming)
Enter the passcode and [Enter] or [ENTER] to turn off (disarm) all areas where the user has
authority and are areas within the scope of the keypad.
Set Duress +1 Using RPS
1. Go to PANEL WIDE PARAMETERS→Miscellaneous→Duress Type. Select 1.
2. Go to AREA WIDE PARAMETERS→Area Parameters→Duress Enable. Select YES.
3. Go to User Interface→Authority Levels. In the authority levels to be used, select E for the
Send Duress parameter.
Keypad Commands
Function Command
All On (Turns on [arms] the
current area with delay)
CMD 1
All On, Instant CMD 1 1
Part On, Instant CMD 2
Part On (with delay) CMD 3
Watch CMD 6
See Alarms CMD 4 0*
Reset Sensors CMD 4 7
Extend Close CMD 5 1
Bypass CMD 0
Unbypass CMD 0 0
Table 9.1: Keypad Commands
*Supported by B920/B930 keypads only.
Legacy Keypads: D1255, D1260, D1265
If your system includes D1255, D1260, or D1265 legacy keypads, you can initiate the
commands described in the previous table from those keypads. These are the only commands
available from those keypads.
9
9.1
9.1.1
9.1.2
9.1.3
9.2
9.2.1
22 en | Turning the System ON or OFF and Keypad Commands for B920/B930 Control Panel
2014.05 | 05 | F.01U.265.463 Quick Reference Guide Bosch Security Systems, Inc.
To Next Page
Loading...
