Upgrade D9412GV4/D7412GV4 Hardware and
Programming
Receive Existing Control Panel Programming
Notice!
GV4 control panels are not compatible with the D5200 Programmer.
Receive Existing Control Panel Programming with RPS
Notice!
5.15 is required when upgrading GV4 v2.00 control panel from v1 to v2.
1. In RPS, double-click on the control panel name.
2. Click Connect. Once connected, the Panel Sync window appears.
3. Select the Receive Panel Data option button and click OK.
Upgrade Previous GV Series Hardware to a D9412GV4/
D7412GV4 v1.00 Control Panel
Use the following procedure to upgrade the hardware from a previous GV Series control panel
to a D9412GV4/D7412GV4 v1.00 control panel.
Notice!
Upgrading from GV4 control panel v1.xx to v2.xx does not require hardware changes.
Prepare to Remove Existing Hardware
1. Power down the existing control panel by disconnecting the battery and the AC power.
2. Remove the four removable terminal strips by tilting the strip up and outward. Do not
remove the wiring from the terminal strip.
Figure 3.1: Removable Terminal Strips
3
3.1
3.1.1
3.2
3.2.1
8 en | Upgrade D9412GV4/D7412GV4 Hardware and Programming Control Panel
2014.05 | 05 | F.01U.265.463 Quick Reference Guide Bosch Security Systems, Inc.
To Next Page
Loading...
