Bosch D7412GV4 - Table of Contents

Table of contents
1
Introduction 5
1.1 About documentation 5
1.2 Determine Bosch Security Systems, Inc. Product Manufacturing Dates 5
2
D9412GV4/D7412GV4 Control Panel Connections 6
3
Upgrade D9412GV4/D7412GV4 Hardware and Programming 8
3.1 Receive Existing Control Panel Programming 8
3.1.1 Receive Existing Control Panel Programming with RPS 8
3.2 Upgrade Previous GV Series Hardware to a D9412GV4/D7412GV4 v1.00 Control Panel 8
3.2.1 Prepare to Remove Existing Hardware 8
3.2.2 Remove the Existing Control Panel 9
3.2.3 Install the D9412GV4/D7412GV4 v2.00 Control Panel in the Enclosure 9
3.2.4 Replace the Terminal Strips 10
3.3 Upgrade Programming to a D9412GV4/D7412GV4 v2.00 Control Panel 10
3.3.1 Upgrade a GV4 (version 1.00 – 1.99), GV3 Series, GV2 Series, G Series, or Non-G Series
Control Panel to a GV4 v2.00 or Later Using Remote Programming Software (RPS) 5.15
or Later
11
4
Programming the Control Panel 13
4.1 RPS Programming over a Network Using the DX4020 Ethernet Network Interface Module 13
4.2 RPS Programming over a Network Using the ITS-DX4020-G GPRS/GSM Communicator 13
4.3 RPS Programming Using the DX4010V2 RS-232/USB Serial Interface Module 13
4.4 RPS Programming Using the B420 Conettix Ethernet Communication Module 13
4.5 RPS Programming Using the B426 Conettix Ethernet Communication Module 13
4.6 Programming Using the Installer Menu 13
5
Programming to Set Up Central Station Reporting 14
5.1 Basic Telephone Set Up in RPS 14
5.2 Basic Internet Protocol (IP) 14
5.3 Account Number 15
6
Programming the Control Panel for Common Reporting Options 16
6.1 Set Up Daily Test Report Using RPS 16
6.2 Set Up Open and Close Reports Using RPS 16
6.2.1 Area Wide Parameters 16
6.2.2 Set Authority Level 16
7
Setting Up Points and Outputs 17
7.1 Using the Relay Option Within Point Assignments 17
7.2 Point Index (Default Values) 18
8
Add System Users Locally With a Keypad 20
8.1 Adding a User 20
8.2 Configuring the User’s Passcode 20
8.3 Configuring the User's Name 20
8.4 Configuring the User's Level 20
8.5 Configuring a RADION keyfob or an Inovonics Transmitter for the User 20
8.6 Adding a Card for the User 21
9
Turning the System ON or OFF and Keypad Commands for B920/B930 22
9.1 Turning the System On and Off 22
9.1.1 Turning All On (Arming) 22
9.1.2 Turning Off (Disarming) 22
9.1.3 Set Duress +1 Using RPS 22
Control Panel Table of Contents | en 3
Bosch Security Systems, Inc. Quick Reference Guide 2014.05 | 05 | F.01U.265.463