Bosch D9412GV2 - Page 125

D9412GV2/D7412GV2 | Troubleshooting Guide | 4.0 Appendix
.
Bosch Security Systems, Inc. | 11/05 | F01U011024B 125
4.3.3 Receiving Control Panel Programming Using
the D5200 Programmer
4.3.4 Sending Programming Changes to the
Control Panel Using the D5200 Programmer
1. Connect the programming cord to the
Communicator port on the D5200, and to the
four-pin programming jack marked PROG on
the control panel.
1. Press the [SEND (LOAD)] key.
2. When the record is sent, the top line changes to
SEND SUCCESSFUL.
2.
You can press the [SEND (LOAD)] key on
Press [ON] to turn on the D5200.
the D5200 Programmer at any time.
3. If necessary, enter the correct password and
press [ENTER].
3. Reboot the control panel to synchronize the
numeric keys.
4.
Highlight the handler by pressing [↑] or [↓], then
press [ENTER GROUP].
In this example, the 9000MAIN handler is
highlighted.
5.
N
Select
EWRECORD and press the red [RECV
(COPY)] key to copy the handler from the
control panel.
6. When D5200 receives the record, the top line
changes to RECEIVE SUCCESSFUL.