D9412GV2/D7412GV2 | Troubleshooting Guide | 4.0 Appendix
.
Bosch Security Systems, Inc. | 11/05 | F01U011024B 133
D9133TTL-E
Table 70: D9133TTL-E Specifications
Dimensions (Enclosure) 17.8 cm x 11.4 cm (7 in. x 4.5 in)
Current Draw 140 mA maximum
Operation Voltage 12 VDC Nominal
Connectors Control Panel: SDI Bus terminal block
LAN/WAN: RJ-45 modular jack (Ethernet)
Ethernet Cable Category 3 or better unshielded twisted pair
Maximum Length: 100 m (328 ft)
Interface IEEE 802.3
Default IP Address 192.168.000.002
PC9133TTL-E
Table 71: PC9133TTL-E Specifications
Dimensions (Enclosure) 17.8 cm x 11.4 cm (7 in. x 4.5 in)
Current Draw 140 mA maximum
Operation Voltage 12 VDC Nominal
Connectors Control Panel: SDI Bus Terminal block
LAN/WAN: RJ-45 modular jack (Ethernet)
Ethernet Cable Category 5 or better unshielded twisted pair
Maximum Length: 100 m (328 ft)
Interface IEEE 802.3
Compatibility GV2 Control Panels (D9412GV2, D7412GV2, and D7212GV2)
9000 Series Panels (D9412, D9112, D7412, D7212, D9412G and D7412G),
Version 6.0 or later
Default IP Address 192.168.000.002
4.5 Glossary
addressable point: The physical hardware that is programmed, using either DIP switches or a programmer, to a
specific point number or numbers. This point number must also exist in the control panel’s programming as a
programmed point.
device: A physical piece of hardware that detects an event and provides an open or short to the Addressable or
on-board point.
on-board point: The device connection terminals that are part of the control panel.
point expansion technology: A module that connects to the control panel’s Zonex bus, and that directly
(D8128) or indirectly (all modules other than D8128) connects Addressable Points to the control panel.
programmed point: The point number that is programmed in the control panel using the RADXPNTS handler
in either the D5200 Programmer or RPS (Remote Programming Software).
To Next Page
Loading...
