6.3.3
DIVAR 2000 / DIVAR 3000 / DIVAR
38 en | Settings
5000
Recording
Enter here the relevant settings for each connected channel. In most cases you can encode 2
streams for each connected channel. If required, use the Default button to reset all encode
fields to the factory default. Use the Copy button to copy identical settings from one channel
to other channel(s).
Encode settings are:
– Channel: Select a connected channel (default is 1)
– Type: Select from Regular/Motion/Alarm (default is Regular)
– Resolution: System
– Stream 1
– Stream 2
– Frame rate (per second):
– Bit rate in Kb/second (this will depend on the setting for Resolution above):
2016.09 | v1.0 | AM18-Q0717 Operation Manual Bosch Security Systems
To Next Page
Loading...
