-5-
H%(&% %&$'&! %I
- NEVER use grinding wheels, abrasive cut-off
wheels, fric tion wheels (metal slitting blades) wire
wheels or buffing wheels.
.USE ONLY RECOMMENDED ACCESSORIES.
/Crosscutting operations are more conveniently
worked and with greater safety if an auxiliary wood
facing is attached to the miter gauge. (See Page 26).
0Make sure the top of the cutting tool rotates toward
you when standing in normal operating position. Also
make sure the cutting tool, arbor collars and arbor
nut are installed pro p erly. Keep the cutting tool as
low as possible for the oper ation being performed.
Keep all guards in place whenever possible.
GDo not use any blade or other cutting tool marked
for an operating speed less than 5000 R.P.M. Never
use a cutting tool larger in diameter than the diame-
ter for which the saw was designed. For greatest
safety and efficiency when rip ping, use the maximum
diameter blade for which the saw is designed, since
under these conditions the spreader is near est the
blade.
1Make sure the table insert is flush or slightly below
the table surface on all sides except for rear side.
NEVER oper ate the saw unless the proper insert is
installed.
& %&+
SAFETY IS A COMBINATION OF OPERATOR
COMMON SENSE AND ALERTNESS AT ALL
TIMES WHEN THE TABLE SAW IS BEING USED.
Do not allow familiarity (gained
from fre quent use of your table
saw) to become com mon place. Always remember
that a careless fraction of a second is sufficient to
inflict severe injury.
The operation of
any power tool
can result in for-
eign objects being
thrown into the
eyes, which can
result in severe
eye damage. Al-
ways wear safety
goggles that comply with ANSI Z87.1 (shown on
pack age) before commencing power tool operation.
%;91 0A?@ />1-@10 .E <;C1>
?-:05:3 ?-C5:3 3>5:05:3
0>5885:3 -:0 ;@41> /;:?@>A/@5;: -/@5B5@51?
/;:@-5:? /4195/-8? 7:;C: @; /-A?1 /-:/1>
.5>@40121/@?;>;@41>>1<>;0A/@5B14->9%;91
1D-9<81?;2@41?1/4195/-8?->1
• Lead from lead-based paints,
• Crystalline silica from bricks and cement and other
masonry products, and
• Arsenic and chromium from chemically treated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are spe-
cially designed to filter out microscopic particles.
12;>11-/4A?1
>1B51C-88C->:5:3?
8;/-@10;:@41@-.81?-C
005@5;:-8%-21@E$A81?
To Next Page
Loading...
