EasyManua.ls Logo

Bosch i:SY - Symbols in this Manual; Terms

Bosch i:SY
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
Basic information
Label for environmentally-harmful hazardous sub-
stances. Exercise special caution when handling prod-
ucts labelled as such� Observe disposal guidelines!
Label for waste materials intended for recycling� Sort
the packaging before you dispose of it� Dispose of
cardboard and carton as waste paper and foils via the
recyclable material collection service�
Symbol confirming conformity with guidelines for prod-
ucts corresponding to the requirements of the Europe-
an General Product Safety Directive�
Labelling for products that may only be used indoors�
The 230 V ~/50 Hz mains connection corresponds to
protection class II.
Symbol for direct current (DC)�
5.2 Symbols in this manual
1� Instructions for steps to be performed in a particu-
lar order begin with a number
Steps to be performed in no particular order begin
with a dot�
Lists begin with a so-called dash�
Note: Supplementary notes regarding steps to be per-
formed or use�
5.3 Terms
Terms with “nominal”: Nominal output, nominal capacitance etc�
are values stipulated according to the design� The actual values
may differ from the nominal values depending on operating con-
ditions�
E-bike (Pedelec/EPAC): An e-bike is a bike powered by an elec-
trical auxiliary motor. E-bikes of this kind are also referred to as
pedelecs (pedal electric cycle) or EPAC (electric power assisted
cycles)� The term “e-bike” will be used hereinafter
Capacitance: The amount of electrical charge in the unit “Ah” if the
rechargeable battery has been completely charged (see chapter
“Fundamental information / Symbols and terms / Units”)�
Charging cycle: Refers to fully charging a completely depleted re-
chargeable battery
Memory effect: Refers to the loss in the capacitance of rechargea-
ble batteries if they are not completely charged (does not apply to
lithium ion rechargeable batteries)�
Pedal drive: Assembly consisting of pedal, crank arm and chain
wheel�

Table of Contents

Related product manuals