58
Care
13.2 Speed sensor
The speed sensor and the corresponding spoke magnet must be
mounted so that the spoke magnet is at least 5 mm and no more
than 17 mm away from the speed sensor when it moves past it
during one full revolution�
Fig.: Speed sensor
1 Sensor 2 Spoke magnet
1
2
If the distance is too small or too great, the speed indicator on the
control computer will not work and the e-bike drive will operate in
the emergency programme�
1� To set the spoke magnet, loosen the screw of the spoke
magnet�
2� Arrange the spoke magnet as shown in Fig�: “Speed sensor”�
3� Tighten the screw. Do not use excessive force in the pro-
cess�
• If the speed is still not shown on the speed indicator, please
contact your specialist dealer�
CAUTION
The drive and rechargeable battery may become very hot
in the event of errors. You could injure yourself in the event
of contact with your skin
Risk of injury!
• Read the chapter “Operation” completely before you
switch it on for the first time
To Next Page
Loading...
