39
Operation
– NuVinci pedalling frequency/gear (only for models with a
“NuVinci H|Sync” gear shift):Displaying and setting the desired
pedalling frequency and the gear.
Note: You can access this view directly by pushing the
button
for 1 second�
• Change the desired pedalling frequency or the gear by push-
ing the – (minus) or + (plus) button on the control unit�
• To switch from “NuVinci pedalling frequency” to “NuVinci
gear”, push the
button for 1 second�
• To switch from “NuVinci gear” to “NuVinci pedalling frequen-
cy”, briefly push the
button�
12.2.10.4 Resetting the indicators (Reset)
Note: This chapter only applies to the “Active or PerformanceLine”,
if applicable in the optional version “Intuvia eShift”.
Resetting the distance, cycling time and average:
1� To simultaneously reset the “Distance”, “Cycling time” and
“Average”, push the
button repeatedly until one of these
three views is shown�
2� Push the RESET button until the indicator is set to zero.
This will also reset the values for the two other views. It is not pos-
sible to perform an individual reset�
Fig.: Buttons on the control computer
1 Reset 2 Button
1
2
Resetting maximum:
1� With the
button, switch to the “Maximum” view.
2� Push the RESET button until the indicator is reset to zero.
Resetting the Range:
1� With the
button, switch to the “Range” view�
2� Push the RESET button until the indicator is reset to the fac-
tory default value�
12.2.11 Basic settings
Note: This chapter only applies to the “ActiveLine”, “Performance-
Line” and “Purion” (if applicable, see chapter “Operation / Nyon”)�
You can select the following basic settings:
– Unit km/mi: Indicator for speed and distance in kilometres
or miles�
To Next Page
Loading...
