38
Operation
If no bar is shown, the rechargeable battery charge for the drive
has been used up� The drive will be deactivated� The display and
lighting will be supplied with energy for another 2 hours�
12.2.10.2 Cycling data
Note: This chapter only applies to the “ActiveLine” and the
“PerformanceLine”�
• Read the current speed shown in the middle of the indicator
(see Fig�: “Indicators of the control computer”)�
Fig.: Indicators on the control computer
1 Speed 2 Operating display
1
2
The operating display is a combination of a value and text display
field (see Fig�: “Indicators of the control computer”)� The following
views are available for selection on the operating display:
– Range: remaining range if conditions remain the same
(estimate)�
– Distance: the distance covered since the last reset�
– Cycling time: the riding time attained since the last reset�
– Average: the average speed attained since the last reset�
– Maximum: the maximum speed attained since the last reset.
– Time: current time�
– Total distance: Displays the total distance covered with the
e-bike (reset not possible)�
• To change the view, push the
button repeatedly until the
desired view appears (see Fig�: “Control unit” and Fig�: “But-
tons on the control computer”)�
Fig.: Control unit
Control unit with the buttons + (plus), – (minus) and the
button
(only with the “ActiveLine” or “PerformanceLine”)�
12.2.10.3 Optional indicators
Note: This chapter only applies to the “ActiveLine” or “Perfor-
manceLine” with the option “Intuvia eShift” and electronic gear
shift�
– Gear (only for models with a “Shimano Di2” gear shift): Gear
indicator�
To Next Page
Loading...
