32
Operation
Fig.: Rechargeable battery removed
1 Charging plug 2 Charging slot
1
2
Note: To check the rechargeable battery charge, push the but-
ton on the rechargeable battery�
12� Once the charging process is complete, the charging indica-
tor on the rechargeable battery goes out�
13� Pull the charging plug out of the rechargeable battery�
14� Pull the mains plug out of the socket�
15� Only when the rechargeable battery is inserted: Close the
charging slot with the cover�
12.2 Control computer
12.2.1 Switching on and off
If the control computer is not inserted in the holder, it can be
switched on separately to read the cycling data and for settings
(see following chapter “Insertion and removal”)�
Note:After 1 minute of inactivity, the control computer, which has
been removed, will automatically switch off�
• To switch on the removed control computer, push the button
�
• To switch off the removed control computer, push the button
again�
Note: If the Nyon control computer has been removed, the “Dash-
board” operating mode will appear once it has been switched on�
With the Nyon control computer inserted, the operating mode
“Ride” is displayed (see chapter “Operation / Nyon / Control com-
puter”)�
12.2.2 Insertion and removal
• To insert, place the control computer in the front of the holder
(see Fig� : “Inserting the control computer”)�
• To remove the control computer, push the locking mechanism
and push the control computer forward out of the holder�
• Remove the control computer when you park the e-bike
unless you are using the removal lock (see the following chap-
ter “Removal lock”)�
To Next Page
Loading...
