30
Operation
• If you cannot park your e-bike under shelter, remove the re-
chargeable battery to charge it (see chapter “Operation / Re-
chargeable battery / Removing the rechargeable battery”)�
• Remove any dirt on the charging slot and the contacts with a
dry cloth�
• Only charge the rechargeable battery under supervision�
5� When the rechargeable battery is inserted: Switch the e-bike
off (see the Chapter “Operation / E-bike /Deactivating the
e-bike”)�
Note: During the charging process, the e-bike cannot be switched
on when the rechargeable battery is inserted. You can remove
or insert the control computer during the charging process (see
chapter “Operation / Control computer”)�
When the control computer is inserted, the backlight on the display
panel will be activated at low brightness� “Bicycle is being charged”
will appear in the text display field. The internal rechargeable bat-
tery of the control computer is charged at the same time�
NOTICE
If there is no bar blinking on the charging indicator after the
charger has been connected to an empty rechargeable
battery, the rechargeable battery or the charger is dam-
aged. If several bars are blinking, a protective function is
active�
Risk of damage!
• Disconnect the charger from the rechargeable battery
and the power supply�
• Have your specialist dealer check the rechargeable bat-
tery and charger�
1� When the rechargeable battery is removed: Place the re-
chargeable battery on a clean, solid and non-flammable
surface�
2� Insert the device plug in the mains connector jack of the
charger (see Fig�: “Mains socket”)�
3� Insert the mains plug of the charger in a socket.
4� Only when the rechargeable battery is inserted: Open the
cover of the charging slot�
5� Insert the charging plug in the charging slot (see Fig.: “Inserted
rechargeable battery” and Fig�: “Removed rechargeable
battery”)�
The charging process will start� The charging progress is displayed
on the charging indicator of the rechargeable battery (see chapter
“Charging indicator”)�
6� Monitor the charging process�
7� Insert the device plug into the mains connector jack of the
charger (see Fig�:Device jack on the charger)�
8� Insert the mains plug of the charger in a socket.
9� Only when the rechargeable battery is inserted: Open the
cover of the charging slot�
10� Insert the charging plug in the charging slot (see Fig.:Charg-
ing slot on the rechargeable battery and Fig�:Charging slot
on the removed rechargeable battery)�
To Next Page
Loading...
