Bosch KTS 5 Series - Requirements; Hardware; Operating System; Software

1 689 989 289 2014-12-04
|
Robert Bosch GmbH
20 | KTS 530 / 540 / 570 (KTS 5 Series) | Description of unit
en
3.2 Requirements
3.2.1 Hardware
PC/Laptop with at least one free USB interface.
KTS modules can be used with the following Bosch
products:
R Emissions System Analysis
R FSA 740, FSA 760
R BEA 810, BEA 840, BEA 850, BEA 550, BEA 950
3.2.2 Operating system
Operating system USB Bluetooth
Win XP/Win Vista/Win 7/ Win 8 x x
3.2.3 Software
In order to operate the KTS module, the current
ESI[tronic] software must be installed and enabled on
the PC/laptop. Extra costs apply in this case.
3.3 Delivery specification
Description Order Number
System tester KTS 530
*)
System tester KTS 540
*)
System tester KTS 570
*)
–
–
–
Bluetooth USB Adapter (KTS 540 / 570) 1 687 023 449
OBD diagnosis cable 3 m (KTS 530) 1 684 465 557
OBD diagnosis cable 1.5 m
(KTS 540 / 570)
1 684 465 555
UNI connection cable 4 core 1 684 463 539
USB connection cable 3 m 1 684 465 562
Power pack
Power supply cable
1 687 023 620
1 684 461 106
Measuring cable blue (KTS 530/KTS 540) 1 684 430 066
Measuring cable yellow (KTS 530/KTS 540) 1 684 430 067
Measuring cable red/black (KTS 570) 1 684 463 214
Measuring cable blue/yellow (KTS 570) 1 684 463 550
Test tip red (1x, with KTS 570 2x) 1 684 485 035
Ground cable black 1 684 430 068
Terminal clip, black 1 684 480 022
Case 1 685 438 648
Mount
with sheet-metal screw (2x)
and fillister head screw (3x)
1 681 398 030
2 910 611 406
2 910 641 118
DVD1 ESI[tronic]
Diagnosis and technology 1 987 729 601
DVD ESI[tronic] 2.0 1 987 P12 037
Important information and safety instructions 1 689 979 922
Product description 1 689 979 987
*)
depending on order
! Only use the UNI connecting cable (1 684 463 539)
for measurements with less than 30 V.
! Use measuring leads for measurements smaller than
60 VDC, 30 VAC or 42 VACpeak only!
The accessories must only be used in circuits
which are not connected to a mains voltage
supply (measuring category 0 according to
EN 61010-2-030:2010). The enclosed accesso-
ries must only be used with Bosch products,
and at voltages below the voltage value as
imprinted on the accessories. When combin-
ing accessories, it must be ensured that the
lowest voltage value imprinted on the acces-
sories is not exceeded.
3.4 Special accessories
Information on special accessories, such as e.g. vehicle-
specific connecting cables, additional measuring cables
and connecting cables can be obtained from your
Bosch representative.